![]() Speech processing should be turned off, the Mic Gain should be set so that the rig does not go into ALC, mic equalization (MIC EQ) shoul.d be set to OFF, digital noise reduction (DNR) should be set to OFF, the digital notch filter (DNF) should be set to OFF, and you need to back the power off to something like 25 watts. You can set up your transceiver with this. That will put the transceiver into transmit mode and also send a signal. If you would like to set levels, on the main screen you can select the Tune button. Your transceiver should go into transmit mode, but no data will be transmitted. If WSJT-X is satisfied, the button will turn green. When you’re ready, click on the Test CAT button.You can consult the WSJT-X online manual for more information. WSJT-X will not select the correct register, so be sure to select which register prior to using WSJT-X. I have this set up in one of the band-stacking registers. NOTE THAT you must place the rig into the DATA USB mode. The Transmit Audio Source is grayed out.In the next column, under PTT method, select CAT.NOTE THAT this must match the setting in MENU 040 CAT RTS, which must be set to ENABLE ![]() Check the box for Force Control Lines and check the box for RTS.Set Data Bits to Eight and Stop Bits to Two.I use 38,400, the max rate the ‘3000 will accept. NOTE THAT this must match the setting in MENU 038 CAT RATE. Choose a baud rate for communications between the computer and the ‘3000.Note this is true even if you’re using the USB cable (which I am). Under CAT Control, select the serial port that is the “enhanced” port.Leave the Poll Interval at 1 sec unless you have strong reason to change it. For rig, choose FT-DX5000, because the FTdx3000 is not listed.See text for detailed explanations, because some of the settings require corresponding settings in the FTdx3000’s menu. Note that since the FTdx3000 is not one of the listed radios, we’re going to modify the settings for the FTdx5000.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |